Thank you for visiting Bikes Built Better’s Tech Discussion Forum

Do Not Post Here For Support

Use Contact Form For Fast Customer Support

Forum Registration has been disabled due to spamming the board. Previously registered users have been saved and information is safe and secure. We left the forums open to browse but have deleted many of the posts that had been compromised. We will post new tech information here in the future but if you have a question or need service please use our
Contact Form Located Here.

Ape Bars fit on a 2008 FLSTSB Cross Bones

To ask a question or post a topic for Softails
Start a New Topic Here
Post Reply
webuser
Posts: 16
Joined: Tue Dec 23, 2008 10:07 am
Contact:

Ape Bars fit on a 2008 FLSTSB Cross Bones

Post by webuser »

Would Part #40-5156 Ape Bars fit on a 2008 FLSTSB Cross Bones ?
Steffridesabuell
Site Admin
Posts: 20
Joined: Wed May 21, 2008 10:29 am
Contact:

Re: Ape Bars fit on a 2008 FLSTSB Cross Bones

Post by Steffridesabuell »

Sorry, John, but the 40-5156 14" black 1-1/4" apes will not fit on a 2008 Crossbones. The Crossbones has a springer fork, and the risers are farther apart than they would be on a bike with telescopic forks. That wouldn't be a problem on a 1" handlebar; (though you would see some of the knurling between the risers) but with a 1-1/4" bar like this the clamping area is machined down to 1" and it's only wide enough to accomodate a set of risers from a telescopic fork.
You could use the Wild 1 Chubby 12.5" black Springer apes ($224.95) or the
Wild 1 Chubby 16" black Springer apes ($239.95). You could also use the Bikers Choice 40-0187 12.5" chromed Springer apes ($165.95), and have them powder-coated. (We have a very good local powder coating shop.)
Another idea would be to use a kit that converts your bike to telescopic-width risers (about $225.00) and then replace your stock risers with 3" or 4" straight risers (about $50.00 to $100) then you could use those 14" Bikers Choice 1-1/4" 40-5156 apes. The conversion kit and risers could also be powder-coated black.
Once you get the riser thing resolved, you might need to extend the handlebar wiring harnesses and use a longer clutch cable, throttle cables, and brake line. Can't really tell about that stuff until you've got the handlebars on the bike, because the Crossbones has pretty wide handlebars and sometimes you can replace wide bars with high bars and get away without changing cables.
Post Reply